User manual

7MC1000 - NTP Time Reference System - User Manual - Version 2.0
Section 3: Network setup
From this point, the network setup menu may be exited by a further
three presses of the ‘ENTER’ switch.
3.3 - Programming static IP settings.
If DHCP operation is disabled, the MC1000 uses the IP address,
subnet and gateway address as programmed in the network setup
menu.
The IP settings can be adjusted one byte at a time with the selected
byte ashing. The ‘UP’ and ‘DOWN’ multi-function switches increment
and decrement the byte value; the ‘LEFT’ and ‘RIGHT’ multi-function
switches are used to change the selected byte. Pressing the ‘ENTER’
switch will move on to the next screen or nally exit the menu.
ENTER
ENTER
ENTERENTER
ENTER
IP address screen before a
DHCP lease is obtained.
IP address screen after a
DHCP lease is obtained.