Instruction manual

. .
4 Controls 40
Clicking on the down arrow next to the view name, brings up the View
control menu. You can switch the current view from this menu, create a
new view from the default view, duplicate the current view, rename the
current view, edit the current view, which brings up a View page of the
Preferences dialog, or delete the current view.
Sequences:
The Output Sequence Toolbar is a drop-down list containing
sequences of analog or digital outputs defined in the Sequence
page of the Preferences dialog window. Clicking the Sequence
button will fire the output sequence selected from the list.
Selecting a new sequence in the drop-down list also automatically
fires that sequence.
Stimulator
Toolbar
Pulse Mode
Figure 4-8: The Stimulator Pulse toolbar in the DataTrax2 Main window.
Amp: Amplitude of the stimulus pulse in Volts.
#pulses: Number of Pulses.
Width(ms): Width of the pulse in milliseconds (ms).
F(Hz): Frequency of stimulation in Hertz (Hz) (1Hz=1 cycle/second, in this example, five
pulses would be given every second.
HP: Holding Potential
Apply: When clicked applies any changes to the stimulus protocol made through the Stimu-
lator Toolbar. Clicking Apply while recording will send a stimulus pulse from the output.
Clicking the down arrow next to the Apply button, shows a menu.
All options in this menu may not be available for all hardware. On
hardware that allows it, Apply will wait until a “good” time to apply
the changes, i.e., until a pulse is completed, before changing the
number of pulses.
•Stop: Stop the stimulator.