Instruction manual

6 Input and Output 95
On the Stimulator page, select Pulses as the stimulating mode and set the parameters.
• Toolbar Steps
Freq (Hz) = 1; Amp (V) = 0.05; Time (ms) = 0.1.
• Initial Parameters
Delay 5 ms
Amplitude 0.25 V
Number of Pulses 1
Pulse Width 0.1 s
Time Off 0.1 s
Holding Voltage 0 V
Sequence Page
Figure 6-20: Output sequences page of the Preferences dialog window.
1 On the Sequences page, add a CAPRecruit sequence to the list of current sequences. Type the name
CAPRecruit in the Edit box next to the Current Sequence Label, and click the New button.
2 Select the state titled Inc Pulse Amplitude under Stim 1 from the list of states on the left side of the
page.
3 Click on the button Add State to Sequence to add the state to the CAPRecruit sequence.
4 Click OK at the bottom of the page.