Instruction manual

SI-H Muscle Testers

WORLD PRECISION IN STRU MENTS

Heating Indicator–A ﬂ ashing arrow pointing up (↑) indicates that the cuvette is heating.

Setup

1. Turn on the system.

2. Line up the cuvette connector with the port on the SI-TCM2, press it into place and

screw the outer ring of the connector to secure the connector.

3. Press the Setup button to toggle through the setup parameters.

4. Press the Display button to save the conﬁ guration and return to the normal display.

NOTE: The unit remembers the state of all the parameters, even after it is powered

off. To reset the factory defaults, turn the unit off, press both the Up and Down but-

tons simultaneously while you turn the system back on.

Choosing a Display Mode

To toggle through the display modes, press the Display button. Press one time to see the

Channel 1 Only display. Press it again to see the Channel 2 Only display. Press it a third

time to return to the Two Channel display.

Setup Menu

Press the Setup button to toggle through the Setup menu and cycle through the list of

available parameters. Parameters are shown in Fig. 38.

Channel 1 Setpoint

CH1 Setpoint

CH2 High Alarm Setpoint

CH2 High Alarm

CH2 Low Alarm Setpoint

CH2 Low Alarm

Channel 2 Setpoint

CH2 Setpoint

Backlight

Backlight Level

CH 1 Low Alarm Setpoint

CH1 Low Alarm

CH 1 Alarm Enable

CH1 Alarm

CH 1 High Alarm Setpoint

CH1 High Alarm

CH 2 Alarm Enable

CH2 Alarm

Fig. 38 The Setup button lets you toggle through the list of parameters.

Adjusting the Setpoint

1. Press the Setup button. The Channel 1 setpoint displays. To modify the Channel 2

setpoint, press the Setup button until “CH2 Setpoint” displays.