Operation Manual

7
5. Using your Inspection Camera
5.1. Inserting batteries
As soon as the red LED lights come
on, the batteries are exhausted and
need to be replaced.
To change the batteries, open the
battery compartment cover on the
back of the camera by pressing
the lower lug upwards a little and
lifting the cover o.
Remove any batteries present and
insert new batteries in accordance
with the symbols in the base of the
battery compartment. Your camera
is now ready for use.
5.2. Switching on and o
To swith your Inspection Camera on, press and hold the on/o switch for appox. 3 seconds until
the monitor lights up. The green LED will also light up.
On switching the camera on, the LED lighting always switches on at the highest brightness setting
regardless of how it was set when last used.
To switch the camera o, press the on/o switch again.
5.3. Mirroring the image
You can mirror the monitor image vertically and horizontally to achieve optimum reproduction.
Every time you press the button, the image will be mirrored vertically and horizontally
alternately. This creates a total of four presentation variants.
When switching the camera on, the original - correctly oriented - monitor image will be displayed
again.
Note:
• UseonlybatteriesoftypeAAMignonLR6(1.5V)orrechargeablebatterieswiththesame
 specicationforyourInspectionCamera.