User Manual

7
DRUM/CADDY ASSEMBLY (continued)
Installing Handle
Press and hold the two Release Buttons
while installing Handle into Handle
Receptacles in Drum (See illustration).
NOTE: An audible snap of the Release
Buttons indicates successful engagement
of Handle.
Removing Handle
Press and hold the two Release Buttons,
as shown. While firmly pushing in
Release Buttons, pull Handle upwards to
remove (see illustration).
4
. Slide open end of Axle through Caddy
Left making sure the Leg Slot lines up
with the Cradle Hole. Slide all the way
through the Caddy Right. Light taps
with a Mallet may be required to fully
insert Axle.
5. Install second Wheel onto Axle with
smooth portion of Wheel facing
outward.
6. Install the second Cap Nut. Tap gently
until Cap Nut is firmly seated.
7. Using a Rubber Mallet or Hammer,
gently tap the Wheel Cap onto the
Right Wheel until the Wheel Cap is
firmly seated onto the Wheel. This is
required on both Left and Right sides.
8. Insert the Caster Stem into the Socket
of the Caster Foot, as shown. (Front
Caster Only).
9. With a slight twisting motion, push on
the Caster until the Ball on the Caster
Stem is inserted all the way into the
Socket. You will be able to hear the
Ball snap into the Socket and the
Caster will swivel easily when
positioning is correct.
Mallet
Wheel
Cap
Socket
Caster Stem
Caster Ball
SP6852-2 Workshop 14 Gallon.qxp_WS1400CA0 8/27/18 3:37 PM Page 7