Operator`s manual

INSTRUCTIONS (continued)

MODELS GLPF-442 / 448 / 5548

ATTACHMENT TO PRIME MOVER

——————————————————

The Models GLPF-442, GLPF-448, and GLPF-5548 are

specifically designed for tractor front loaders with the

Euro or Global bucket quick-change system.

The models GLPF-442/448 have a load rating of 4,000

lbs.

The model GLPF-5548 has a load rating of 5,500 lbs.

ATTACHING

1. To prepare the loader for attachment, pull and rotate

handle to open latch (A).

2. Extend attachment cylinders to angle attaching

brackets forward.

3. Drive forward, adjusting loader height and position

until the bar (B) is under hooks (C) and tabs (D) are

on the center side of the hooks.

4. Raise loader and retract tilt cylinders until latch

closes.

5. Lower attachment and shut off engine. Installation is

now complete.

DETACHING

1. Lower pallet fork to ground. Place the transmission in

PARK and shut off engine and remove key.

2. Pull and rotate handle to open latch (A).

3. Start tractor and lower attachment to ground. Slowly

extend bucket tilt cylinders until loader clears the latch

plate. Lower loader until bar clears the hooks.

4. Drive tractor in reverse until loader is clear of the

attachment.

OBEY ALL SAFETY WARNINGS!

CAUTION! ALWAYS CHECK LATCH PINS

BEFORE TILTING OR OPERATING

ANY ATTACHMENT.

NOTE: Latch automatically closes on some global

carrier. Always check latch pins.