Operator`s manual

18
MODELS JDPF-H48048 & H48060
——————————————————
These two models are designed for the John Deere
H480 loader. The Model JDPF-H48048 has 48" long fork
tines and the Model JDPF-H48060 has 60" long fork
tines. Both models are rated at 7,500 Ib. with the load 24"
in front of the fork frame and evenly distributed on the two
fork tines.
The connection to the loader is the Global Series II.
The forks are 1.75" x 4.75" width Class Ill solid type
forks that are sliding adjustable on a 50" wide carriage.
Connection instructions for the JDPF-480 Models are
similar to the ones for the standard Euro or Global units.
(See page 19.)
INSTRUCTIONS (continued)
MODEL JDPF-6748
ATTACHMENT TO PRIME MOVER
——————————————————
The Model JDPF-6748 pallet fork is specifically
designed for John Deere 600 and 700 series loaders with
quik-change latches. It has a load rating of up to 5,500
lbs.
NOTE: Procedure is the same for all attachments.
Bucket attachment shown.
ATTACHING
1. Extend bucket tilt cylinders to angle attaching brackets
forward.
NOTE: Angle must be greater than that of the
brackets on the rear of the pallet fork.
2. 600/700 – Drive forward, adjusting loader height and
position until the top of the bracket is aligned with the
pins (A).
3. Raise loader to engage hooks and retract attachment
cylinders quickly.
4. 600/700 – Raise loader until you can check that pins
(D) on both sides have fully dropped.
5. Lower attachment, shut off engine and remove key.
DETACHING
1. Lower pallet fork to ground. Place the transmission in
PARK and shut off engine and remove key.
2. Lift and rotate latches (A) up on both sides of attach-
ment.
3. Start tractor and lower attachment to ground. Slowly
extend bucket tilt cylinders until loader brackets clear
the latch pin pockets. Lower loader until holder clears
the pins.
4. Drive tractor in reverse until loader is clear of the
attachment.
700 SERIES
700 SERIES BOLT-ON LATCH SHOWN
CAUTION! ALWAYS CHECK LATCH PINS
BEFORE TILTING OR OPERATING
ANY ATTACHMENT.