Workrite Sierra HX™ & HXL™ Assembly Instructions for 2-leg Electric Workcenters #1500215- Rev A
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables E List of Parts, grouped by carton K B C F #12 × ¾" Pan Head Laminate Top Screw Qty: 32 Short Bracket Qty: 4 Rear Bracket Qty: 1 D Left End Bracket Qty: 1 Right End Bracket Qty: 1 Companion Leg Qty: 1 G I J Control Leg Qty: 1 Feet Glides Qty: 4 L #8 × ⅝" Pan Head Screw Qty: 12 M 4 mm Allen Wrench Qty: 1 O Leg Cable - 1 meter Qty: 2 P Control Box Qty: 1 Q Cable Spool Qty: 2 R Cable Loops Qty: 10
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables 1 a Verify that you have all the hardware and tools needed for the assembly. Check your cartons against the list on page 2 to verify that you have all the parts needed.
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables 3 Attach Base to Worksurface and Tighten Screws 3 screws per Short Bracket If you do not have a Workrite worksurface skip to step 4 a K If you have a Workrite worksurface: Position leg assemblies to align mounting holes in brackets to pre-drilled holes in Top (A) then attach loosely using Pan Head Top Screws (K).
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables c Attach loosely using Pan Head Top Screws (K). If you use an electric screwdriver, be sure it is on the lowest torque setting to avoid stripping the holes in the top. d Tighten all screws connecting brackets to leg assemblies. e Then tighten all screws attaching brackets to top.
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables 6 a Attach Control Box to Tabletop Position Control Box (P). If you have a Workrite tabletop: Locate the four pilot holes for the Control Box and proceed to Step b . If you do not have a Workrite tabletop: Place Control Box (P) in position and use a pencil to mark pilot hole placement. Control Box should be placed towards rear center of tabletop.
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables 8 Attach Cable Spools and Cable Loops Attach Cable Spool (Q) with the #12 × ¾"Pan Head Laminate screw (K) and Cable Loops (R) to underside of worksurface using #8 × ⅝"Pan Head Screw (L) making sure to wrap the Cable Loop around the cable prior to attaching. If you do NOT have a Workrite worksurface, mount cable spools in a convenient location between legs and control box.
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 2-leg Tables 10 a b c Connect Power Cord to the Power Supply and put workcenter upright Connect the Power Cord (S) to the Power Supply. Turn the table over into an upright position. Plug the Power Cord into the power outlet. b S c a 11 Adjust Feet Guides If necessary, adjust leveling guides on table feet to level the worksurface. Unscrew to increase height, screw in to decrease height.
