Assembly Instructions for Front and Top-Crank models Instruction Manual

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Workrite Sierra™ Crank Workcenters - Assembly Instructions
L
a
b
c
AttachCrankTubesandCrossbarstoSideLegsandTable
UseLongEndHexShafttoconnectRightLegtoCrankTube,insertingshortendofshaftintoleg
and long end into Crank Tube.
UseShortEndHexShafttoconnectLeftLegtoCrankTube,insertingshortendofshaftintoleg
and long end into Crank Tube.
AttachCrossbarstosidelegsusingtwoButtonheadMachineScrewsperleg.
Base-only models, skip to step 5.
AttachtopplateofLegstodeskusing10WoodScrewsprovided.Usethelocatingholes.ForFront-
crankmodels,keepthetwoholesnearesttheinsideofthelegwherethecrankwillbeinsertedfree
fornow.Ifyouuseanelectricscrewdriver,besureitisonthelowesttorquesettingtoavoidstrip-
pingthethreads.
Proceed to Step 5 on page 10.
a
b
d
P
M
J
J
H
P
I
I
d
RightLeg
Left Leg
d
c
c
4
H