Assembly Instructions for Front and Top-Crank models Instruction Manual

4 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra™ Crank Workcenters - Assembly Instructions
AttachCrankTubesandCrossbarstoCenterLegandTable
UseShortEndHexShafttoconnectCrankTubetogearmechanisminsideofCenterLegpointing
toRightLeg.The shorter end of the hex shaft should be inserted into the Center Leg.
UseLongEndHexShafttoconnectCrankTubetogearmechanisminothersideofCenterLeg.See
diagram for correct placement and orientation.
SlideCrossbarsoverLegBracketsonCenterLegandsecureusingtwoButtonheadMachineScrews
foreachCrossbar.Base-Only models, please skip to Step 4.
AttachtopplateofLegtodeskusing4WoodScrewsprovided.Usethelocatingholes.Ifyouuse
anelectricscrewdriver,besureitisonthelowesttorquesettingtoavoidstrippingthethreads.
a
b
c
a
b
P
d
Left Leg
RightLeg
3
To avoid stripping the threads when
attaching crossbars, always insert
and make the rst few turns of
the screw BY HAND with an Allen
wrench, ensuring it is in straight.
M
2
3-leg Tables, 90º corner:AssembleCenterLeg,thenlayoutthemajorpieces
Forassemblyoftwo-piecetops,pleaserefertoseparateinstructions.
AttachTopBracketandCrossbarBrackettoCenterLeg.Use2ButtonHeadBoltstosecure
CrossbarBracketandfourtosecureTopBrackettoLeg.
Layoutthelegs,crossbarsandcranktubesintheproperlocation.
d
b
c
a
L
J
I
B
H
B
A
D
I
H
A
c
b
c
E
G
D
F