Installation Instructions Workrite Poise™ #1500138 - Rev.
Workrite Poise™ FLAT SCREEN MONITOR ARM Contents Important Safety Instructions............................. 2 Components and Fasteners................................. 3 PA1000 Assembly Instructions............................. 4 LCD Monitor Attachment..................................... 5 Cable Management............................................ 6 Arm Adjustment................................................ 7 Desk Base Template...........................................
Components Fasteners A a Desk Base with Clamp Plastic Spacer x1 b x1 B x1 c Washer x2 Arm Assembly d x1 C Round Head Cap Screw Plastic Cap Disc Spring Washer x1 e M5 Hex Wrench x1 x1 D Base Cushion M8 Thread Rod x1 x1 E f g Wing Nut U Bracket x1 h M4 Hex Wrench x1 F x1 i Holding Tab M8 Flat Head Cap Screw x8 x2 j Round Head Cap Screw x2 k M4 6mm Screw x4 l M4 10mm Screw x4 m Cable Clip x1 n M5 10mm Set Screw x1 o M3 6mm Screw x2 p M2.
PA1000 Assembly Instructions Step 8 C convex side face up Step 6 b c d B Step 5 a Step 8 Step 4 Step 7 p A p n n Step 2 D Step 1 Step 3 i Step 2 bolt hole >12mm f Step 3 Bracket Steps: j c Clamp CLAMP MOUNT g E GROMMET MOUNT Clamp Mount: 1 Mount Bracket to Desk Base then tighten (i)Flat Head Cap Screws with (e)M5 Hex Wrench. 2 Attach (D)Base Cushion to (A)Desk Base.
LCD Monitor Attachment 100mm VESA standard 75mm VESA standard The combination 75/100mm VESA plate is pre-mounted to the Workrite Poise. Mount the LCD monitor directly to the front plate of the Tilt Adjustment Pivot with the supplied M4 x 6mm (or M4 x 10mm) screws or screws provided by the manufacturer. For 100mm x 100mm or 75mm x 75mm standard, use the 4 outer corner holes or 4 inner corner holes on the front plate respectively.
Cable Management Workrite ics Ergonom F Cable Mount FOREARM 1 Thread monitor cables through Cable Mount located on underside of Forearm. 2 Place Holding Tabs (F) in center slot as shown and slide into place along Mount track. Use four tabs on each side. EXTENSION DESK BASE Secure Velcro® strips under side of Extension around monitor cables, leaving slack for monitor cables to move freely.
Arm Adjustment Adjust the Monitor Tilt Action Tensioning Screw Depending on the size of your LCD monitor, it may be required to adjust the Tilt Adjustment screw. If the monitor doesn’t hold its tilt position or is too hard to tilt, adjust the screw directly behind the LCD screen with the M5 Allen wrench provided (clockwise to tighten, counter-clockwise to loosen as shown on the graphic near the adjustment screw). Check the monitor, and adjust again as necessary.
Desk Base Template for Grommet Mount Drill hole at least ½" in diameter 2" Workrite reserves the right to make changes to its products without notice. No liability is assumed for any misprinting or error in this publication. Copyright 2009. All rights reserved. 8 Workrite Ergonomics 800.959.9675 www.workriteergo.
