Safety Data Sheet

SPECIFICATIONS
Charger
Batteries
Charging Time
Drill No Load Speed
Torque Settings
Torque
Drill Chuck Capacity
Max Drilling Capacity Steel / Wood
Weight
Battery
Charger
120V ～ 60Hz
1.5Ah
3-5H
0-400/0-1500/min-1
21+1
23 N.M.
3/8"(10mm) keyless
8mm / 22mm
0.95Kg(2.09lbs)
0.34Kg(0.75lbs)
WJ-Y112150350W
INTENDED USE
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and
plastic.
B) TO REMOVE OR INSTALL BATTERY PACK
(SEE A)
Depress the battery pack release button (7) to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
with slight pressure will be sufficient.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.The Li-ion battery is protected against
deep discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.In a warm
environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the
battery to cool down before recharging.When the
battery pack is charged for the first time and after
prolonged storage, the battery pack will accept a
100% charge after several charge and discharge
cycles.
OPERATING INSTRUCTIONS FOR DRILL DRIVER
Before using the tool, read the instruction book
carefully.
NOTE:
A
7
9