Safety Data Sheet

Depress the On/Off switch (8) to start and release it to

stop your drill. The on/off switch is fitted with a brake

function which stops your chuck immediately when

you quickly release the switch.It is also a variable

speed switch that delivers higher speed and torque

with increased trigger pressure. Speed is controlled by

the amount of switch trigger pression.

ON / OFF SWITCH (SEE B)1.

The switch trigger can be locked in the OFF position.

This helps to reduce the possibility of accidental

starting when not in use. To lock the switch trigger,

place the rotation control in the center position.

SWITCH LOCK2.

Do not operate for long periods at low speed

because excess heat will be produced internally.

WARNING!

Never change the direction of rotation when the

chuck is rotating, wait until it has stopped!

WARNING!

To prevent gear damage, always allow the chuck to

come to a complete stop before changing the

direction of rotation or the two-speed gear control.

WARNING!

OPERATION



The drill has a two-speed gear control (3) designed for

drilling or driving at LOW (mark is 1) or HIGH (mark is 2)

speeds. A slide switch is located on top of the drill to

select either LOW or HIGH speed. When using the drill

in the LOW speed range, the speed will decrease and

the drill will have greater power and torque. When

using the drill in the HIGH speed range, the speed will

increase and the drill will have less power and torque.

GEAR I

Low speed range: for screw driving or working with

large drilling diameter

GEAR II

High speed range: for working with small drilling

diameter

TWO-SPEED GEAR CONTROL (SEE D)

For drilling and screw driving use forward rotation (4)

marked “ ” (lever is moved to the left). Only use

reverse rotation marked “ ” (lever is moved to the

right) to remove screws or release a jammed drill bit.

REVERSIBLE (SEE C1, C2)3.

EASE

RELEASE