Instructions / Assembly

ECH89301 / ECH89307

EXECUTIVE ECO LEATHER CHAIR

ASSEMBLY INSTRUCTIONS

STEP 1

STEP 4

STEP 2

STEP 3

Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.

STEP 1 Insert ﬁve Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place. Insert Pneumatic Cylinder (3)

into Base (1) and slip Bellows (4) over Pneumatic Cylinder (3).

STEP 2 Attach Seat Plate (5) to Seat Cushion (6) with the arrow towards the front of the chair using four Short Screws (10).

FULLY TIGHTEN ALL SHORT SCREWS (10) USING ALLEN WRENCH (14).

STEP 3 Attach Back Support (13) to Seat Cushion (6) and over Seat Plate (5) using four Short Screws (10). DO NOT FULLY TIGHTEN

SCREWS. Attach Arms (8L & 8R) to Seat Cushion (6) using two Lock Washers (9) and two Medium Screws (11) for

each Arm (8R & 8L). DO NOT FULLY TIGHTEN SCREWS.

STEP 4 Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure. Secure Arms (8L & 8R) to Back

Cushion (7) using one Long Screw (12) for each Arm (8). FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (14).

ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.

PA RT QTY

1. Base .......................1

2. Casters .....................5

3. Pneumatic Cylinder ............1

4. Bellows .....................1

5. Seat Plate ...................1

6. Seat Cushion .................1

7. Back Cushion ................1

8. Arms (8R & 8L) ...............2

9. Lock Washers ................4

10. Short Screws ................8

11. Medium Screws ..............4

12. Long Screws ................2

13. Back Support (pre-installed) ....1

14. Allen Wrench (not shown) ......1