Technical data

84
CTC EcoZenith i550 Pro
For the installer
12. Transportation, unpacking
and installation
This section is intended for the technician responsible for one or more of the installations
necessary for the CTC EcoZenith i550 Pro to perform according to the property owner’s
wishes. Take your time going through functions and settings with the property owner
and answer any questions. Both you and the EcoZenith i550 Pro benefit from a user
who has completely understood how the system operates and should be maintained.
12.1 Transportation
Transport the unit to the installation site before removing the packaging.
Handle the CTC EcoZenith i550 Pro in one of the following ways:
• Forklift
• Lifting eye which is fitted in the socket in the middle of the top of the CTC
EcoZenith i550 Pro.
• Lifting band around the pallet. NB: Can only be used with the packaging on.
• Remember that the product has a high centre of gravity and should be handled
with caution.
12.2 Unpacking
When the CTC EcoZenith i550 Pro has been placed at the installation site, the
packaging can be removed. Check that the product has not been damaged in transit.
Report any transport damage to the carrier.
12.3 Fitting rear insulation and plastic top
cover
The rear insulation sections and top cover should be fitted before the CTC EcoZenith
i550 Pro is placed against a wall or in a corner for pipe and electrical connection. These
parts are delivered separately and they are easier to fit if there is space around the unit.
Begin with the left rear insulation. Turn out the insulation, locate it in the recesses in the
front insulation and then turn it in against the tank. Repeat this procedure for the right
rear insulation. Note that the right rear insulation needs to be turned out quite a lot for it
to locate easily in the recesses.
!
The product must
be transported and
stored in an upright
position.
Left rear insulation
Recesses in the front insulation
Right rear insulation
For the installer