Specifications

D-4
Group 3: Output Function Parameters
Factory
Parameters Explanation Settings Default
Setting
d0: Not Used
03-00 Multi-Function Output1 d1: AC Drive Operational 08
(Relay Output) d2: Max. Output Freq. Attained
d3: Zero Speed
d4: Over Torque
03-01 Multi-Function Output2 d5: Base-Block (B.B.) 01
(Photocoupler Output) d6: Low Voltage Detection
d7: AC Drive Operation Mode
d8: Fault Indication
03-02 Multi-Function Output3 d9: Desired Freq. Attained 02
d10: PLC Program Running
d11: PLC Program Step Complete
d12: PLC Program Complete
d13: PLC Program Operation Pause
d14: Terminal Count Value Attained
d15: Preliminary Count Value Attained
03-03 Multi-Function Output4 d16: Auxiliary Motor No.1 20
d17: Auxiliary Motor No.2
d18: Auxiliary Motor No.3
d19: Heat Sink Overheat Warning
d20: AC Drive Ready
d21 Emergency Stop Indication
d22: Desired Frequency Attained 2
d23: Software Break Signal
d24: Zero Speed Output Signal
03-04 Desired Freq. Attained 0.00 to 400.00 Hz 0.00
d0: Output Frequency
d1: Output Current
03-05 Analog Output Signal d2: Output Voltage 0
d3: Frequency command
d4: Motor output speed
d5: Output power factor
03-06 Analog Output Gain ★ 1 to 200% 100
03-07 Digital Output Gain ★ 1 to 20 01
03-08 Terminal Count Value 0 to 65500 0
03-09 Preliminary Count Value 0 to 65500 0
03-10 Desired Freq. attained 2 0.00 to 400.00 Hz 0.00
APPENDIX D: ZVD Summary of Default Program Codes