Specifications

4-2
4.2.1 Setpoint
4.2.1.1 Select the method of supplying remote setpoint using Code 02–00.
4.2.1.2 For the method chosen above, wire according to page E-3.
4.2.1.3 Input the setpoint command.
4.2.2 Operation Command Control (Run/Stop)
4.2.2.1
Select the method of operation command control using Code 02–01.
4.2.2.2 If the method of control is using external contacts, select one
contact or two contact using Code 02 – 05.
4.2.2.3 For the method of control chosen, wire according to page E-3.
4.2.2.4 Provide the method of operation command control chosen.
4.2.3 Remote Monitoring ZVD Operation
4.2.3.1 Analog Output, 0 – 10 VDC.
4.2.3.1.1 Select the parameter to be monitored using Code 03 – 05.
4.2.3.1.2 Wire the analog output circuit according to page E-3.
4.1.6.3 Press the MODE key until no LED’s are lit on the left side of the
display. This is the multi-function display and will indicate the
parameter selected by Code 00 – 04.
4.1.6.3.1 If the action indicated in paragraph 4.1.6.2.1 has been
performed, the display will show the last parameter
viewed. Calling up Code 00 – 04 will reflect this new
parameter. NOTE: To view encoder RPM, Code 00 – 04
must be set back to 11.
4.1.7 Faults
4.1.7.1 Should a fault occur, the ZVD will stop and display the fault des-
ignation. See the Troubleshooting section for fault designations.
4.1.7.2 Once the fault has been cleared, press the STOP/RESET key to
clear the display and return to a ready condition.
4.1 Local Keypad Operation (continued)
4.2 Remote Operation