Specifications

3-3

3.3 Standard Program Code Changes (continued)

Code 07 – 02 (Torque Boost) = 0 (Code 00 - 09 = 2 or 3); = 8 (Code 00 – 09 = 0 or 1)

Code 07 – 04 (Number of Motor Poles) = 4 (Base Speed = 1800 RPM)

Code 07 – 05 (Motor Auto Detection) = 1, then press RUN (To Auto Detect Motor

Resistance); = 0 (Normal)

Code 07 – 06 (Motor Line-to-line Resistance) = ____________ (Auto Detect through or

Measure Using an Ohmmeter)

Code 07 – 10 (Current Limit) = 100 (Software Version 3.12 or later)

Code 10 – 08 (Feedback Signal Detection Time) = 5 (Seconds)

Code 10 – 09 (Transmission Fault Treatment) = 1 (Alarm and RAMP to stop)

Code 10 – 10 (PG Pulse Range) = ____________ (PPR of Feedback Sensor)

Code 10 – 11 (PG Input) = 1 (Single Phase Feedback)

Code 10 – 12 (Proportional Speed Control (P)) = 1.0 (Proportional Setting)

Code 10 – 13 (Integral Speed Control (I)) = .05 (Integral Setting)

Code 10 – 14 (Speed Control Output Frequency Limit) = 10.0 (Hz)

Code 10 – 15 (Feedback Display Factor (1800 rpm @ 60 Hz)) = ____________

Choices: 120 PPR sensor (125), 60 PPR sensor (250), or 30 PPR sensor

(500) (See Code 10 – 10)

NOTE: To reset all codes to factory defaults, set Code 00 – 02 = 10. Reprogram, as

above.