MANUFACTURING NUMBERS: 9300530 9 3 0 0 5 32 9300534 9 3 0 0 571 9 3 0 0 574 9 3 0 0 575 9 3 0 0 57 7 9500593 EGG STATION AN Model ES-600, ES-602, ES-604, & ES-1200 I T A T IO L IS N S T ED CM C L IS T ED US P/N 1010883 Rev.
EGG STATION TABLE OF CONTENTS Owner Information......................................................2 General.......................................................................2 Warranty Information..................................................2 Service/Technical Assistance.....................................3 Important Safety Information.....................................4 Specifications..............................................................5 Electrical Ratings...........................
EGG STATION OWNER INFORMATION (continued) Service/Technical Assistance Refer to the service agency directory and fill in the information below: If you experience any problems with the installation or operation of your unit, contact your local Roundup Authorized Service Agency. They can be found in the service agency directory packaged with the equipment. Authorized Service Agency Name: Phone No.: Fill in the information below and have it handy when calling your Authorized Service Agency for assistance.
EGG STATION IMPORTANT SAFETY INFORMATION (continued) • WARNING ELECTRICAL SHOCK HAZARD. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. In addition to the warnings and cautions in this manual, use the following guidelines for safe operation of the unit. • Read all instructions before using equipment. • For your safety, the equipment is furnished with a properly grounded cord connector. Do NOT attempt to defeat the grounded connector.
EGG STATION SPECIFICATIONS Electrical Cord & Plug Configurations Electrical Ratings Model & Mfg. No. Volts Watts Amp Hertz ES-600 9300530 Model & Mfg. No. 208 2400 11.5 50/60 ES-602 9300571 9300577 ES-600 9300530 208 2400 11.5 50/60 ES-602 9300571 9300577 ES-604 9300574 9300575 208 2400 11.5 50/60 ES-1200 9300532 9300534 208 2400 11.5 50/60 ES-604 9300593 208/220 - 240~ 2400 / 3150 11.5 / 10.9 13.
EGG STATION INSTALLATION Unpacking CAUTION All electrical service connections must be in accordance with local electrical codes and any other applicable codes. 1. Remove unit and all packing materials from shipping carton. NOTE: If any parts are missing or damaged, contact A.J. Antunes & Co. Technical Service IMMEDIATELY at 1-877-392-7854 (Toll free in the U.S. and Canada) or 630-784-1000.) WARNING ELECTRICAL SHOCK HAZARD. 2. Remove information packet.
EGG STATION OPERATION Preparing Unit To ensure proper cooking, place eggs into rings in numerical order from 1 to 12 as shown below. 1. Turn the unit on and allow it to warm up for approximately 20–30 minutes. NOTE: During warmup, the Ready Indicator Light flashes. The Ready Indicator Light stays on once the unit reaches operating temperature. 10 2. If necessary, install the Top Cover according to Figure 1. FIFO (First in, first out) The first egg in should always be the first egg out 3.
EGG STATION OPERATION (continued) 10. Press the START/STOP button to begin the cooking cycle. 3. Crack the eggs into the Egg Rings from right to left as shown in Figure 2, starting at the row closest to the front of the unit. NOTE: The Cooking Indicator Light will light when the START/STOP button is pressed and released. 6. Break the egg yolks if desired and close the Top Cover. 11.
EGG STATION OPERATION (continued) Bacon Timer* (All units EXCEPT Mfg. No. 9300534) 1 READY 2'-00" If, during the standby mode, the Bacon Indicator Light is not lit, it means that the Bacon Timer is disabled. To enable the Bacon Timer, with the unit turned on, press the TIME 1 and TIME 2 buttons simultaneously for 3 or more seconds. The Bacon Indicator Light will turn on. The Bacon Timer is now enabled. BACON 2 2'-30" POWER START/STOP COOKING For Mfg. No.
EGG STATION MAINTENANCE 5. Clean the Egg Rings, Egg Rack, Cover, and Service Pans in hot, soapy water. Rinse these items in clear water and allow to air dry. WARNING Turn the power off, unplug the power cord, and allow the unit to cool down before performing any service or maintenance. 6. Reassemble the unit. Checking Cycle Times (Monthly) (All units EXCEPT Mfg. No. 9300534) CAUTION Chlorides or phosphates in cleaning agents (e.g.
EGG STATION MAINTENANCE (continued) Checking Cycle Times (Monthly) (Mfg. No. 9300534 ONLY) Checking Grill Platen Temperature NOTE: A pyrometer is required for this procedure. CAUTION: Grill surfaces will be hot. Care should be taken when operating this piece of equipment. WARNING This procedure exposes you to hot surfaces. Use extreme care when performing procedure to avoid personal injury. NOTE: A stopwatch is required for this procedure. 1. Turn the unit on and allow it to warm up for 30 minutes. 1.
EGG STATION TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing. Problem Possible Cause Unit fails to operate and control panel lights fail to signal on. Corrective Action No power/low power. Make sure the power is on and the power cord is locked into place. Check the main circuit breakers. Inoperable electrical outlet.
EGG STATION BUZZ YELLOW CR5 The control Board has three on board LEDs (Figure 5) to determine the status of the unit and to assist in troubleshooting. R18 STATUS GREEN R20 Green (Diagnostic): This LED should be off in normal operation. If any of the 5 potential faults are detected by the Control Board, this LED will repeatedly blink either 1 through 5 times with a 2-second pause in between (see the Green LED Blink Codes section below).
EGG STATION WIRING DIAGRAM NOTE: ALL WIRES TO BE 14 GA. TFE-200°C UNLESS OTHERWISE SPECIFIED. # 18 GA. TFE-200°C 22 GA.
EGG STATION REPLACEMENT PARTS 76 30 3 5 66 8 29 4 26 1 54 58 55 31 51 24 53 59 64 61 60 63 25 57 18 62 23 52 2 7 6 32 33 P/N 1010883 Rev.
EGG STATION REPLACEMENT PARTS (continued) 28 65 28 48 28 65 65 14 16 74 15 48 48 34 35 9 34 10 11 27 27 19 20 27 45 21 45 45 28 28 65 65 48 48 18 17 74 74 34 36 13 12 27 45 27 19 22 45 16 P/N 1010883 Rev.
EGG STATION REPLACEMENT PARTS (continued) Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Part No. Description Qty. Item 0021327 Nose Piece Weldment 1 210K230 Bumper, Recess Leg 1” 1 (Set of 4 including 4 screws) 7000379 Grill Platen 1 7000674 Grill Platen 1 (Mfg. No. 9300593 Only) 040P138* Lock-nut, Conduit - 1/2” NPT 1 040K251 Strain Relief Kit 1 2180270 Service Pan 2 (For Mfg. No. 9300530 & 9300532) 2180277 Service Pan (For Mfg. No.
EGG STATION REPLACEMENT PARTS (continued) Item Part Description No. 47 310P149* Scr, Mach.
EGG STATION NOTES P/N 1010883 Rev.
LIMITED WARRANTY Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from electrical and mechanical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.
