Technical data

40
ESD 10 K
Voltage regulator
ESD 10 K keeps output voltage constant at a predetermined value, with an input voltage that cons-
tantly oscillates between 140 and 250 V (with 220 V devices) or between 60 and 130 V (with 110V
devices). It is possible to connect a 10 kVA  x load.
It features a male CEE connector with 32 A and 3 poles, with 2 schuko connectors (one for 110V-
10A, another for 230V-16 A) or terminals.
Many features are available to ensure output signal integrity: protections against overvoltage (255
V), overheat (95º) or overload. The voltage regulators automatically turn off if a value is exceed. They
emit an acoustic signal and indicate the problem on the display. Additionally, a double circuit breaker
(63 A) and a switch for output voltage selection (1% or 3%) are available on front panel.
To avoid noises coming from the switch, ESD 10 K features a time delay circuit (3 or 6 sec.). After
this time, normal operating mode starts automatically. Two large displays show the information about
devices status, like input, output and current voltage. Finally, it incorporates an internal cooling sys-
tem so components are maintained at a low temperature.
FEATURES
- Mains supply: AC 140-250 V / 60-130 V.
- Maximum joint load: 10 kVA.
- Time delay: 3 or 6 sec.
- Output voltage precision: 1% or 3%.
- Protections:
- Overvoltage.
- Overheat (95°).
- Overload.
- Dimensions (WxHxD): 305 x 260 x 460 mm.
VOLTAGE REGULATORS
MAINS SUPPLY WITH
PROTECTION LID AND
OUTPUT VOLTAGE SELECTOR
THREE OUTPUTS AVAILABLE
- 110 V, 10 A.
- 220 V, 16 A.
- 220 V, 32 A (L+N+E).
catalogo_iluminacion_2013.indd 40 09/09/2013 17:12:45