Technical data

27
voltage regulators
ESD 10K
voltage regulator
ESD 10 K is a voltage regulator that maintains a constant output supply when voltage varies between 140 and 250 V (with 220 V devices) or between 60 and 130 V (with 110V devices). It is
possible to connect a 10 kVA x load. As many xture performance depends on voltage, it is essential to ensure the regulation and control on these values. Regarding inputs, it features a
male CEE connector with 32 A and 3 poles, with 2 schuko connectors (one for 110V-10 A output and another for 230V-16 A output) or terminals. Two large displays show the information
regarding devices status, like input, output and current voltage.
To avoid noises coming from the switch, ESD 10 K features a time delay circuit (3 or 6 sec.). After this time, the normal operating mode starts automatically.
It features dierent protections to ensure output signal integrity: protections against overvoltage (255 V), overheat (95°) or overload. If one of these values is exceed, units automatically
go o and emit an acoustic signal, indicating it on the display. It also has double circuit breaker (63 A) on front panel and a switch for output voltage selection (1% or 3%). It also includes
a fan that cools the units down.
FEATURES
- Main supply: 60/130 V - 140/250 V AC.
- Maximum joint load: 10 kVA.
- Time delay: 3 or 6 sec.
- Output voltage precision: 1% or 3%.
- Protections:
Overheat (95°).
Overvoltage.
Overload.
- Dimensions (WxHxD): 305 x 260 x 460 mm.
Rear panel
Front panel
THREE OUTPUTS AVAILABLE
- 110 V, 10 A.
- 220 V, 16 A.
- 220 V, 32 A (L+N+E).
MAINS SUPPLY WITH PROTECTION LID
AND OUTPUT VOLTAGE SELECTOR