User Manual

FOCUS:
Adjust the diopter focus until the image is sharp.
POWERING UP:
Once the battery is installed and the 4 steps are completed, press and release the POWER
button. The display will light up to show the unit is on and ready for ranging. The laser will
power down automatically after 10 seconds of non-use.
AIMING RETICLE:
This is shown as point A. in the diagram of the Q6 display. Align this over the object you
would like distance to and then press the FIRE button.
FIRING THE LASER:
To fire the laser, simply look through the ocular lens, press and release the POWER button
once to turn it on, align the reticle over the object you want distance to, and press again to
fire. Within the display are “Firing Indicators” (B.) letting you know the laser is firing. Let go
of the FIRE button once a distance has been displayed.
SCAN:
With the laser on, press and hold the FIRE button, scan back and forth to various objects;
while doing so, watch for changes in the measurement number displayed as you move the
aiming reticle across targeted objects. This is a quick way to get an accurate reading on
multiple objects or hazards.
1. Remove as much dust and dirt as possible from the lenses with ablower or bristled
warranties. Bottom line, our warranty* is about you, not us. Should anyCobalt laser