Technical data

10
Site preparations and guidance
Greenstar FS CDi Regular boilers are designed for
connection to a traditional heating and hot water system.
The major benefits of the Greenstar FS CDi Regular
boiler are:
•
The boiler is compatible with S and Y plan systems
•
The boiler comes with a roll-in boiler tray and
pre-plumbing jig.
Greenstar FS CDi Regular boilers are exceptional for their
number of additional time-saving installation features:
•
Built-in frost sensor for boiler protection
•
Built-in fault finding diagnostics
•
Automatic gas pressure adjustment
•
Highly versatile multi-directional fluing system
•
Combined ignition and control board means fewer
connections
•
A rigid 22mm compression gas connection eliminating
the need for pre-fabricating the gas pipe onto the
isolating valve
•
The large output range capability of the appliances.
Siting of appliance
General
The appliance is not suitable for external installation.
The appliance may be installed in an airing cupboard if
required. See section “Compartment Installation” on
page 11.
Clearances
The following clearances should be allowed for installation
and servicing.
Installation clearances
The minimum space required to install the boiler only.
600mm
600mm
5mm
5mm
410mm
1,200mm
1,450mm
600mm
15mm
5mm
5mm
410mm
1,200mm
865mm
25mm*
*25mm to a removable door
Pipework connections and casing dimensions
Cabinet dimensions (mm)
A 850
B 400
C 600
A
B
C
28mm
22mm
247mm
123mm
A
B
C
Pipework connections
A CH flow 22mm
B Gas inlet 22mm
C CH return 22mm
Service clearances
The minimum space required to service the boiler only.