Installation manual

EXPLANATION OF SYMBOLS AND SAFETY PRECAUTIONS
8 716 115 519a (2009/03)4
1.2 SAFETY PRECAUTIONS
PLEASE READ THESE INSTRUCTIONS CAREFULLY
BEFORE STARTING INSTALLATION:
These installation instructions are applicable to the
Worcester flue kit stated on the front cover of this
manual and must not be used with any other make or
model.
These installation instructions must be read in
conjunction with the appliance manual.
The instructions apply in the UK/IE only and must be
followed except for any statutory obligation.
This flue kit must be installed by a CORGI registered,
competent person. Failure to install correctly could lead
to prosecution.
If you are in any doubt contact the Worcester technical
helpline.
Distance learning and training courses are available from
Worcester.
BENCHMARK:
Please leave these instructions with the completed
Benchmark checklist (or a certificate confirming
compliance with IS 813, EIRE only) with the owner
after installation or servicing.
The Benchmark checklist can be found in the back
two pages of the appliance installation manual.
IF YOU SMELL GAS:
B Do not smoke or strike matches.
B Do not turn electrical switches
ON or OFF.
B Put out naked flames.
B Open doors and windows.
B Keep people away from the affected area.
B Turn off the control valve at the meter.
B Call your gas company.
OR
B Call emergency number 0800 111 999.
USE
This flexible flue system is only suitable for lining
chimneys that conform to the building regulations.
B Do not use this flexible flue as a chimney on its own.
B Do not use this flexible flue outside a masonry or
flueblock chimney.
WORKING AT HEIGHTS:
B Refer to the applicable health & safety regulations.
FITTING AND MODIFICATIONS:
Fitting the flue system to the appliance must be carried
out by a CORGI registered, competent person in
accordance with these installation instructions and the
current Gas Safety Regulations (Installation and Use).
Worcester, Bosch Group recommends that this flue
system is installed by two persons for easier handling of
the components.
Flue systems must not be modified in any way other
than as described in the fitting instructions. Any
misuse or unauthorised modifications to the appliance,
flue or associated components and systems will
invalidate the warranty. The manufacturer accepts no
liability arising from any such actions, excluding
statutory rights.
B Position the flue terminal in such a way so that
combustion products do not enter the building or
cause a nuisance.
B Position the flue in such a way so the flue does not
cause an obstruction.
B Ensure the flue terminal is not obstructed and
combustion products can discharge without
hindrance.
B Fit the flue according to the regulations and
standards stated on page 5.
SERVICING:
Advise the user to have the system serviced annually by
a CORGI registered, competent person using approved
spares, to help maintain the economy, safety and
reliability of the appliance.
B The service engineer must complete the
Service Record on the Benchmark Checklist after
each service.