Installation manual

INSTALLATION

8 716 115 519a (2009/03)

5.5 INSTALLING THE FLUE TERMINAL

B Fit the terminal into the terminal adaptor.

B Check the height is a minimum of 350mm from the top

of chimney to the top of terminal.

B Remove the terminal from the terminal adaptor.

Fig. 26 Checking the height

B Fit the self-adhesive weather seal to the base of the

chimney cowl.

B Fit the terminal through the chimney cowl.

B Re-insert the terminal into the terminal adaptor.

B Mark the cowl securing points.

B Rotate the chimney cowl to drill.

B Insert wall plugs.

B Rotate chimney cowl back.

B Secure chimney cowl with the screws provided.

Fig. 27 Fitting the chimney cowl

To ease the assembly of the flue

components:

B Grease all seals lightly with solvent-free

grease .

B Ensure all seals are seated properly and

are in good condition.

If the chimney cowl is too large:

B Cut the chimney cowl down along the

moulded marks and use the inner set of

securing points.