Installation manual

INSTALLATION

8 716 115 519a (2009/03)14

5. Fit the seal (b) into the first wide recess on the

flexible liner (c). Make sure the seal (b) is not

twisted and is seated properly.

6. Fit the liner (a) into the flexible liner (c).

7. Grease the seal (b).

Fig. 14 Fitting the seal and liner

8. Push the adaptor onto the flexible liner until it

“bottoms out” and the moveable band “clicks” into

place.

If the band does not “click” into place, check:

B the adaptor is pushed down fully

B the adaptor is square to the flexible liner

B the lugs are aligned with their slots in the adaptor

B that the flexible liner is cut correctly

B refer to fig. 16 for help

9. Rotate the moveable band clockwise until it locks in

place.

Fig. 15 Fitting the adaptor onto the flexible liner

Fig. 16 Cutaway view of adaptor fitted to flexible liner