Installation manual

INSTALLATION
8 716 115 519a (2009/03)12
5.2 INSTALLING THE SUPPORT ELBOW
Depending on the depth of the chimney, it may be
necessary to cut the support bar.
B Cut the support bar to fit the chimney as in fig. 8.
B Drill a new hole into the support bar.
Ensure it will match with the securing hole in the
ledge.
Fig. 8 Cutting the support bar
B Measure the depth of the chimney.
B Position the elbow centrally on the elbow support as
shown in fig. 9.
B Secure with the wing nut.
B Grease the seal in the elbow.
Fig. 9 Fitting the elbow onto the elbow support
B Place the elbow assembly in the chimney.
B Ensure that the elbow support is horizontal and the
elbow centrally positioned with the chimney space.
B Secure the assembly with a screw as shown in fig. 10.
Fig. 10 Placing the elbow assembly into the chimney