Instruction manual

All packaging must be placed safely away

from the working area in order to avoid a

potential tripping or slipping hazard.

At all times the correct method for handling

heavy objects should be strictly observed.

Removing the base support board:

It is advised that two or more persons are involved in

the handling of the appliance during the following

procedure.

6 Carefully lay the boiler on its left hand side.

This is where the support board is least

proud of the appliance and there is less risk

of accidental damage to components. At

least two persons will be reqiuired to do this

and the correct method for handling heavy

objects should be strictly adhered to.

Undo the base support board nuts and bolts

(V) removing the bottom two first. The boiler will

drop slightly to the floor so keep fingers away

from the heat exchanger body when it drops.

Then remove the top two bolts and pull the

base support board (W) and its brackets away

from the appliance.

The base support (W) and the brackets

attached to it are no longer required.

Please dispose of them in a responsible

way..

Optional orientation of flow and return pipes:

7 At this point, before mounting the frame on

the wall the orientation of the flow and return

pies can be changed to accomodate supply

from above the appliance.

 To do this release both clamps (X) by

undoing the two bolts. The pipes are

now free to be removed and replaced in the

upright direction (Y).

 Replace the clamps and re-tighten the bolts.

Do not tighten fully so that alignment can be

made when preplumbing before mounting

the appliance.

Note: If a rear exit flue is also used the pipes

whilst in the upright position will have to be

shortened to miss the flue.

UNPACKING THE BOILER

INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER GREENSTAR DANESMOOR WALL MOUNTED OIL 12/18-18/25

8 718 681 134a (08.08)

INSTALLATION