Technical data

Fig.18. Rear Panel Assembly.

Silencer outlet plate

Rear panel

Rear panel bracket

N.B. To prevent water ingress

blank off options not required.

Fire valve entry

Oil pipe entry

Fig.19. Oil Plate Fixing Hole Positions.

12mm

two pipe

option

10mm two pipe option

12mm

single pipe

option

10mm single pipe option

Blanked off

option

Fig.20. Fire Valve Plate.

N.B. The silencer outlet

plate can be fitted in two

positions, depending on

the boiler position within

the Outdoor Pack.

Choose the option

which lines the silencer

outlet plate hole

centrally with the

clamping collar on the

back of the boiler.

3. Open the main oil supply valve at the tank and check for any leaks.

4. Place a suitable container below the bulkhead fitting and

open the valve.

5. Draw off at least 2.5 litres of oil until a steady flow of clear

uncontaminated oil can be seen and turn off the isolating valve.

Note: This method may not be possible on some installations

where a sub-gravity system is used. Where this problem arises

bleed the system using the oil pump as described in Section 12

and remove and clean the oil pump filter to remove any debris

collected as a result of installation.

11.6 Replace the electrical control panel and boiler side panels

in reverse order to the removal procedure of Section 5 and

connect the electrical supply as described in Section 10.