Use and Care Manual

Placement:
Place the product on a level floor or table free of any obstructions.
• Place the product in locations where it will not come in contact with direct sunlight, or hot air from air
conditioning or heating appliances. Such contact can cause the product to deform, change color, or
malfunction.
• Do not place the product near the radio or TV. The product may cause noise on radio and affect the
TV signal.
USING AND CLEANING PRODUCT
3 4
Use with Air Conditioner
Placing the product in front of air
conditioner to circulate cold air
accumulated below creates air
flow and provides better cooling.
Use with a Heater
Sending air flow to corner of the
room where the A/C source is, to
circulate warm air accumulated
above, warms feet.
Circulation
Sending air flow toward the
ceiling reduces room air
temperature variations.
Ventilation
Placing the product by a widow
or a door draws outside air in and
sends in-room air out.
Two-room Circulation
Placing the product in an open
doorway circulates air between
two-rooms.
Drying Laundry
Hanging laundry directly in the
path of air flow helps it dry
quicker.
Product Parts:
FRONT REAR
Handle
Front guard
Main body
Vane
Control panel
Base
Rear guard
Motor
Power cord &
Power plug
Always turn off the power and unplug the power plug from the electric socket when cleaning the product. Use
caution, the motor will be hot immediately after use. Confirm the motor has cooled before cleaning the product.
• Do not use paint thinner, alcohol, benzene, alkaline detergent, or bleach, etc. when cleaning the product.
Using such substances can cause damage, malfunctions, or changes in color, shape, and quality.
Caution
How to Use:
Connecting the power plug
Insert the power plug securely all
the way into the electric socket.
Vertical (manual)
Vertical angle can be adjusted
manually across six steps from
20 degrees to 90 degrees.
How to Clean:
Using the product in dusty condition can cause it to malfunction. Check and clean the product regularly.
Wipe lightly using a
soft cloth.
For hard to remove
dirt, wipe using a
cloth containing
a diluted neutral
detergent.
CLAWS
INTERNAL EXTERNAL
1. Unscrew the screw on the back cover of the fan.
2. Press in and disengage the 4 claws on the top and bottom of the front
guard, and then remove the front guard by pulling it toward you.
3. Remove debris using a vacuum cleaner. Wipe off debris that cannot be
removed by vacuuming using a soft cloth.
4. Align claws on the top and bottom of the front guard with the guides on
the back of the guard, and press until it snaps into place.
SCREW
Operation
Turning the knob selects the
desired air flow strength.
Stop
Turn the knob to OFF to stop
operation.
OFF
OFF
AIR FLOW