Specifications

WSP-i450 Rev. 4.0
http://www.woosim.com
19
2
2
.
.
6
6
.
.
1
1
.
.
G
G
A
A
P
P
/
/
H
H
O
O
L
L
E
E
S
S
E
E
N
N
S
S
O
O
R
R
S
S
E
E
T
T
T
T
I
I
N
N
G
G
After setting GAP/HOLE of MARK and AUTO of SENSOR, the printer is required to save
the sensing Gap/Hole so please press the buttons by self-test way and keep pressing the
feed-button only and you can see "sensor setting" on LCD after the self-test ends up and
you can finish pressing the feed-button until after passing the 3rd label.
u When you press FEED button once.
® You will see present MARK mode in the LCD. (Use)
® Press POWER Button once. And then the mark has set to Mark Gap/Hole.
u When you press FEED button once.
® You will see present SENSOR mode in the LCD. (High)
® Press POWER Button once. And then the sensor has set to Sensor Auto.
u When you press FEED button once.
® You will see present POWER DOWN mode in the LCD. (5 minutes)
® Press POWER Button once. And then the Power down has set to
Power down no use.
If all the mode have set, press the POWER Button and the FEED Button
at the same time. After then release the buttons at the same time.
Bluetooth / 57600bps / 7 data bit / Odd parity / 2 stop bit / Density high /
High/ Gap/Hole / Auto / No use