Specifications

ٻۃۏۏۋڕڊڊےےےډےۊۊێۄۈډھۊۈٻ

ڏڑ

ٻٻ4) Any setting that exceeds the specified printing area is ignored.

5) This command function as follows, depending on the print

starting position set by ESC T;

When the starting position is set to the upper left or lower right

of the printing, the vertical motion unit (y) is used.

When the starting position is set to the upper right or lower left

of the printing, the horizontal motion unit (x) is used.

6) The horizontal and vertical motion unit are specified by GS P.

7) The GS P command can change the horizontal (and vertical)

motion unit. However, the value cannot be less than the minimum

horizontal movement amount, and it must be in even units of the

minimum horizontal movement amount.

ڶڭۀہۀۍۀۉھۀڸٻ ڠ

ڠڮڞٻٿڇٻڠڮڞٻگڇٻڠڮڞٻڲڇٻڠڮڞٻڷڇٻڢڮٻٿڇٻڢڮٻګ

ٻٻ

ESC O xL xH yL yH

[Name] Set print starting position.

[Format] ASCII ESC O xL xH yL yH

HEX 1B 4F xL xH yL yH

Decimal 27 79 xL xH yL yH

[Description] Set horizontal starting position and vertical starting position.

Horizontal starting position = (xL + xH * 256) * (horizontal motion unit)

Vertical starting position = (yL + yH * 256) * (vertical motion unit)