Specifications

ٻۃۏۏۋڕڊڊےےےډےۊۊێۄۈډھۊۈٻ

ڎڑ

2) Any setting that exceeds the printable are is ignored

3) When pitch N is specified to the right; nL + nH x 256 = N

When pitch N is specified to the left (the negative direction), use the complement of

65536.

4) The print starting position moves from the current position to [N x horizontal or

vertical motion unit)]

5) The horizontal and vertical motion unit are specified by GS P.

6) The GS P command can change the horizontal (and vertical) motion unit.

However, the value cannot be less than the minimum horizontal movement amount,

and it must be in even units of the minimum horizontal movement amount.

7) In standard mode, the horizontal motion unit is used.

8) In page mode, the horizontal or vertical unit differs as follows, depending on the

starting point of the printing area;

When the starting position is set to the upper left or lower right of the printable area

using ESC T, the horizontal motion unit (x) is used. When the starting position is set

to the upper right or lower left of the printable area using ESC T, the vertical motion

unit (y) is used.

[Reference] ESC $, ESC P

ESC a n

[Name] Select justification

[Format] ASCII ESC a n

HEX 1B 61 n

Decimal 27 97 n

[Range] 0 അ n അ 2

48 അ n അ 50

[Description] Aligns all the data in one line to the specified position. n selects the type of

justification as follows;

n Justification

Left

ustification

Center

ustification