User's Manual

http://www.woosim.com
16
X Press FEED Button two time, Power Lamp twinkles six times and
Error Lamp twinkles once.
→ Press MODE Button one time, Error Lamp twinkles twice after then
press MODE Button again, the Error Lamp will twinkle three times.
( The Density has set to High)
If all the mode have set, press the MODE Button and the FEED Button at the same time
after then release the buttons at the same time.
The printer will print out the mode status which has modified.
(Bluetooth / 38400 bps/ 7 Data bit/ Odd parity/ 1 Stop Bit/Density high/Mark No Use)
If the status is not correct, please try it again according to the procedure.