User's Manual

http://www.woosim.com
15
2
2
.
.
5
5
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
1. Press the MODE Button until the Error Lamp twinkles 5 times.
2. Change the mode and option using the MODE Button according to the MODE
(Table1).
z MODE button : use for changing OPTION status. (Error Lamp)
z FEED button : use for changing MODE status. (Power Lamp)
Ex) The defaults of the printer are :
UART/ 9600 bps/ 8 data bit / No parity/ Density Low
If a user wants to modify the defaults with :
Bluetooth / 38400 bps / 7 data bit/ Even parity/ Density high
X Press MODE Button until Error Lamp twinkles 5 times and release the
button.
→ You will see the Power Lamp twinkles once and the Error Lamp
twinkles once.
→ Press the MODE Button twice and the Error Lamp twinkles three times.
(The interface mode has set to Bluetooth mode.)
X Press FEED button one time, Power Lamp twinkles twice and Error Lamp
twinkles once.
→ Press the MODE Button twice, and the Error Lamp twinkles three times.
(The baud rate has set to 38,400 bps)
X Press FEED Button once, Power Lamp twinkles three times and Error Lamp
twinkles twice.
→ Press MODE Button one time, Error Lamp twinkles one time.
(The Data Bit has set to 7 Data bit)
X Press FEED Button one time, Power Lamp twinkles four times and Error Lamp
twinkles once.
→ Press MODE Butt
on one time, Error Lamp twinkles two times.
(The Parity bit has set to Odd parity bit)