User's Manual

MV-5 Getting Started
1-3
WHAT’S IN THE BOX
The following accessories are included with the MV-5 Processor:
One User Guide (this document)
One Remote Control
Four AAA Batteries (for use with Remote Control)
One Microphone
One Microphone Extender Rod
One 115V Power Cord
Two 220V Power Cords
AVAILABLE OPTIONS
The following accessories are available for purchase as options to
the MV-5 Processor:
• D-1 Dock Station, Part No. 021-18138, allows an iPod to be
connected and controlled by the MV-5 Processor.
• RF-1 RF Receiver Part No. 021-18005, allows the remote control
to operate via RF (Radio Frequencies) and hence gives the
remote a broader operating range.
OPTIONAL D-1 DOCK ACCESSORY
The D-1 Dock optional accessory allows you to enter a new world of
listening enjoyment made possible by combining the increased
storage capacity and playback flexibility of an iPod® (not included)
with the sonic power of your Lexicon receiver. Operation is easy,
you can use your Lexicon remote control or the front panel Tuner
section of the MV-5 to access and control your iPod selections. Just
one simple connection and you’re ready to go!
• Single connection to your Lexicon receiver
• Plays audio from an iPod through your Lexicon receiver
• Controls your iPod through your Lexicon receiver
• Easy track selection with on-screen navigation
• Charges the iPod
OPTIONAL RF-1 RECEIVER
The optional RF-1 Receiver provides a boost to the Lexicon remote
control, allowing multi-directional RF signals to pass through walls,
doors, and floors - both indoors and outdoors. The RF-1 Receiver used
in conjunction with the MV-5 Processor allows you to control
components that are completely out-of-sight, up to 100-feet away.
Since the RF-1 Receiver picks up multi-directional radio frequency
signals, the MV-5 remote control no longer needs to be pointed
directly at the component to control it. Now you can close your
entertainment center doors, hide your components, and still control
them with ease.
The RF-1 Receiver accessory requires no setup to the Lexicon remote
control in order for the feature to work - you need only plug the
optional device into the IR port of the MV-5 rear panel. Every time a
command is sent from the remote control, it sends both a standard IR
and an RF signal. The RF-1 Receiver automatically receives the remote’s
radio signals and translates them into the infrared commands that
control the components.