User's Manual

MV-5 Troubleshooting & Maintenance
6-9
VIDEO RESOLUTIONS TABLE
The MV-5 Processor is designed to allow flexibility in the selection of
video output resolutions. However, there are restrictions on what
resolutions can be made available due to incoming signal
limitations.
If you are not getting the expected resolution options for your
video monitor, it is possible that there is an incompability between
the input setup selections and the incoming signal. The table
below describes those formats that are possible, given a specific
input source and input setup conditions.
Notes:
The following notes refer to the “Note” column in the table.
1. If the HDMI video is copy-protected (HDCP), all analog video
output is blocked.
2. If the analog video signal is Macro-vision protected, the
component video output can only be set to 480i or 480p,
regardless of the output resolution setting.
3. The difference between BYPASS and CONVERSION modes is
where the video encoder is used (CONVERSION) or not
(BYPASS) when the S-video or composite video input is selected.
In CONVERSION mode, digital video from the analog input is
provided to the video encoder and the S-video and composite
video outputs are encoded. In BYPASS mode, the analog input
signal goes to the video output directly, with no encoding.
INPUT
Video Mode
OUTPUT
Source Format HDMI Component S-Video Composite Note
HDMI
480i
FAROUDJA ON
480p ~ 1080i 480p ~ 1080i 480i 480i 1
480p 480p ~ 1080i 480p ~ 1080i - - 1
720p 720p ~ 1080i 720p ~ 1080i - - 1
1080i 1080i 1080i - - 1
Component
Analog
480i 480p ~ 1080i 480p ~ 1080i 480i 480i 2
480p 480p ~ 1080i 480p ~ 1080i - - 2
720p 720p ~ 1080i 720p ~ 1080i - - 2
1080i 1080i 1080i - - 2
S-Video,
Composite
Analog
S-480i 480p ~ 1080i 480p ~ 1080i 480i (from S) 480i (from S) 2
C-480i 480p ~ 1080i 480p ~ 1080i 480i (from C) 480i (from C) 2
S&C - 480i 720p ~ 1080i 720p ~ 1080i 480i (from S) 480i (from S) 2