User's Manual

MV-5 Audio & Video Controls
4-3
When the Active PS is set to “USER”, this indicates a factory default
condition.
Note: Once a Preset location has been selected and saved, the factory
default “USER” condition is not longer available for selection.
The Preset locations cannot be selected and are present only to
identify the current state of each location. If the location indicates
“SET” then the preset location has AUTOCAL settings saved to it. If
the location indicates “FACTORY”, then the preset location has not
been used and remains at the default factory settings.
Note: If all three Preset locations indicate “FACTORY”, then the AUTOCAL
procedure has not yet been done, or at the least, the settings have not been
saved.
For more information on the AUTOCAL process, refer to Section 3:
Setup.
HF SHELF +8dB to -8dB in 1dB increments
Located in the EQ ADJUST menu, the HF SHELF control acts as a
high-frequency shelf filter, which boosts or cuts frequencies above
1kHz.
TONE CONTROLS OFF, ON
Actives or deactivates the Bass and Treble Tone Controls. Bass and
Treble controls are only active when the Tone Control is set to ON.
Note: When the incoming audio datastream is stereo analog, the Tone
Controls are OFF, and the Mode Family is set to STEREO, four different
listening modes are available: 7CH STEREO, 5CH STEREO, 2CH STEREO,
and 2CH BYPASS.
BASS +6dB to -6dB in 1dB increments
Controls the amount of low-frequency boost or cut applied to all of
the audio outputs. Bass is an independent setting for each input,
NOT a global setting.
TREBLE +6dB to -6dB in 1dB increments
Controls the amount of high-frequency boost or cut applied to all
of the audio outputs except for the subwoofers. Treble is an
independent setting for each input, NOT a global setting.
AUDIO STATUS
The AUDIO STATUS menu is an information-only menu identifying
the current audio status of the MV-5.
• INPUT identifies the currently selected input.
• NAME identifies the customer-chosen name for the currently
selected input.
• CONNECTOR identifies the current audio connector in use.
• AUDIO identifies what type of audio signal is in use.
• MODE FAMILY identifies the selected mode family.
• MODE identifies the currently selected listening mode.
Note: The Audio line is dashed out if the audio input is analog.
AUDIO CONTROLS
EQ ADJUST
HF SHELF
AUDIO CONTROLS
TONE CONTROLS: OFF
AUDIO CONTROLS
BASS
AUDIO CONTROLS
TREBLE
AUDIO CONTROLS
AUDIO STATUS
INPUT: HD
MODE FAMILY: LOGIC 7
AUDIO: - - -
NAME:
MODE: MUSIC 5.1
CONNECTOR: ANALOG 3