User's Manual

MV-5 Setup
3-23
clear the test pattern. While test patterns are active, the advanced video
settings can be changed even though the OSD is off.
The MV-5 has a large selection of listening modes to choose from. The list of available listening modes is broken into two parts - the Mode Family
and the Mode. The available listening modes vary depending upon the Mode Family selections, the input setup, and the incoming data stream.
The MV-5 also features the ability to turn off selected listening mode families so that those options do not appear in the list of available listening
modes. See the following section, “Surround Configuration”, for more information. The MV-5 also features the ability to modify elements of the
Dolby listening modes, PLIIx and PLII, to better suit your listening preference. See the “Dolby Configuration” section found later in this chapter for
more information.
SELECTING A LISTENING MODE
The Input Setup menu allows the user to select the initial listening
mode and mode family that will be applied to any incoming data
stream on that specific input. However, setting the input Mode
Family and Mode parameters does not prevent other listening modes
from being available through the Mode buttons.
The Front Panel Mode  and  buttons allow the user to quickly
scan through the available listening modes in the selected family for a
given input or incoming data stream. The Remote Control Channel
 and  buttons perform the same function.
To select a different Mode Family, the Remote Control touch screen
must be set to the first page of the LEX menu. Then selecting the
DOLBY, DTS, DSP, or STER soft button on the remote control switches
the Mode button selections to any listening modes available for each
of those families, respectively.
The MV-5 process of signal identification and listening mode
selection is shown below:
DTS + DOLBY LISTENING MODES
When a DTS soundtrack is playing, the Mode Family menu for DTS
contains two options. The DTS selection provides the currently
available DTS listening modes. The Dolby selection contains two
additional listening modes: DTS + PLIIx Film and DTS + PLIIx Music.
Note: These DTS + Dolby listening modes are ONLY available when the
incoming data stream is DTS.
Incoming Signal
MV-5 identifies
incoming signal
MV-5 identifies which
been turned off
surround modes have
MV-5 builds the
available mode list