User's Manual

Setup Lexicon
3-18
A/D SAMPLE RATE 48 KHZ, 96 KHZ
The MV-5 converts the incoming analog audio signals to digital audio
for all audio processing. The A/D SAMPLE RATE parameter allows you
to select the sample rate of the A/D converters. Some surround
processing modes, such as those in the DSP Mode Family, are only
available at the 48 kHz sampling rate. This setting is only available for
incoming analog audio streams and does not apply to any of the
ANALOG BYPASS modes.
A/V SYNC DELAY 1 TO 180 mS
Delays the audio until it matches the on-screen video. Select a value
to activate an audio signal delay to compensate for video that is
delayed relative to the audio. The A/V sync delay range is 1 to 180 ms
in 1 ms increments. Each input has an independent A/V Sync Delay
parameter.
ADVANCED VIDEO
Selects the ADVANCED VIDEO menu, which provides fine-tuning
adjustments to the video output. For more information, refer to the
next section, “Advanced Video”.
Note: Most of the advanced video parameters are only available when the
V-Process parameter is set to FAROUDJA.
TRIGGER 2 OFF, ON
Selects the TRIGGER 2 parameter, which configures the Trigger
OUT 2 connector on the rear panel. This trigger output can be
configured independently for each input so that a trigger voltage
signal is sent to the Trigger Out 2 connector when a specific input is
selected. If the Trigger 2 parameter is set to ON, it will output its
voltage when the associated input is activated in the Main Zone. It
is not activated by Zone 2 input switching. The default for the
Trigger 2 parameter is OFF.
ZONE-2 OUT ANALOG, DOWN MIX
Identifies the type of audio that is sent to the Zone 2 outputs. The
ANALOG setting is a straight bypass of the Main Zone stereo analog
audio to the Zone 2 outputs. DOWNMIX provides a stereo
downmix of the incoming audio to the Zone 2 outputs.
DOWNMIX, which should be selected for digital or multi-channel
analog sources, is only available if the Main Zone has an input
selected that will accept a downmixed source. The ZONE 2 OUT
parameter is NOT input-specific; a selection made for one input will
be reflected in ALL inputs.
Note: If you have 5.1-channel or 7.1-channel ANALOG AUDIO assigned
to an Input using the BYPASS listening mode, only the Front Left and Front
Right channels will be sent to Zone 2 OUT with the ANALOG setting. In
this condition, DOWNMIX is not available.
The Main Zone and Zone 2 inputs are inter-related. For example,
there is only one HD input that is accessible in both Main Zone and
Zone 2; there are NOT two separate HD inputs. Therefore, to set
the ZONE 2 OUT in a Main Zone input, the same Zone 2 input
must also be selected.
DOWNMIX is only available if the following conditions exist:
• Zone 2 is ON (or the Zone 2 OFF button is not lit).
• Zone 2 has the same input selected as the Main Zone.
• If the Main Zone audio is ANALOG, it is not set to a BYPASS
listening mode.
INPUT SETUPSETUP
A/D SAMPLE RATE
INPUT SETUPSETUP
A/V SYNC DELAY
INPUT SETUPSETUP
ADVANCED VIDEO
INPUT SETUPSETUP
TRIGGER 2
INPUT SETUPSETUP
ZONE-2 OUT