User's Manual

MV-5 Setup
3-17
ANLG AUDIO
Selects the ANLG AUDIO parameter, which assigns one of the rear
panel analog audio input connectors to the current input. Available
selections include None, Analog 1-6, 7.1 Analog, and 5.1 Analog.
Note: Analog audio is not selectable for the Tuner, Dock, and PC inputs.
Refer to Section 5: Tuner, PC, and Dock Controls for more information.
DIG/ANLG AUTO OFF, ON
Selects the DIG/ANLG AUTO parameter, which identifies if the MV-5
should switch to an analog signal source for an input where the
digital input source has been interupted. This feature is particularly
useful with certain cable set-top boxes where the signal is normally
digital but occasionally changes to analog.
The parameter, when set to ON, identifies if there is both a digital
and analog signal present to the input. If this condition is true, then
the MV-5 prioritizes the digital signal over the analog signal. When
the digital signal is interupted, then it switches to the analog signal.
Note: Digital/analog auto switching is not selectable for the Tuner, Dock,
and PC inputs. Refer to Section 5: Tuner, PC, and Dock Controls for more
information.
MODE FAMILY LOGIC 7, DOLBY, DTS, DSP, STEREO
Identifies the surround mode family that is initially applied to the
incoming audio streams for the currently selected input. Other
surround mode families may still be applied. For more information,
refer to the “Listening Modes” section found later in this chapter.
Note: The Mode Family and Mode parameters are connected. The modes
are driven by the mode family selection as well as by the incoming audio
source. The current running data stream dictates what mode family
options are available for selection.
MODE
Identifies the listening mode that is initially applied to the incoming
audio streams for the currently selected mode family. Other listening
modes may still be applied. For more information, refer to the
“Listening Modes” section found later in this chapter.
Note: The Mode Family and Mode parameters are connected. The modes
are driven by the mode family selection as well as by the incoming audio
source. The current running data stream dictates what mode family
options are available for selection.
DEFAULT SUR STANDARD, USE LAST
Identifies the default surround mode that is activated when a digital
source is selected. The STANDARD parameter activates the specific
surround mode encoded by the source input. The USE LAST selection
allows the MV-5 software to “remember” the last used listening
mode for any given input source. Once selected, that mode will
always be active on the corresponding input until another listening
mode is selected. This parameter affects all inputs.
Note: If the LOGIC 7 DEFAULT parameter in the SURROUND CONFIG
menu is set to ON, the USE LAST selection is defeated and the listening
mode will always switch to a LOGIC 7 mode. For normal functionality
with the USE LAST selection, make sure that the LOGIC 7 DEFAULT
parameter is set to OFF.
INPUT SETUPSETUP
ANLG AUDIO
INPUT SETUPSETUP
DIG/ANLG AUTO
INPUT SETUP
SETUP
MODE FAMILY
INPUT SETUPSETUP
MODE
INPUT SETUPSETUP
DEFAULT SUR