User's Manual

Setup Lexicon
3-16
Conv Only - Does not apply any video enhancement or processing
to the incoming video signal, but will output the signal in one of the
following ways, depending on the input source.
• A standard-definition (480i or 576i) analog signal
(composite, S-video, or component) will be converted
so that it is available as an HDMI signal at its input
resolution, as well as at the standard S-video,
composite, or component analog video outputs.
• An analog component high-definition signal will be
digitized and output at its input resolution through the
HDMI outputs and as an analog component signal, but
not through the analog composite or S-video monitor
outputs.
• HDMI signals, regardless of their resolution, will be
output through both the HDMI and analog component
outputs. Program material that carries HDCP encoding
will only be available through the HDMI output.
Bypass – Does not apply any video enhancement or processing to
the incoming video signal, but will output the signal in one of the
following ways, depending on the input source.
• Analog signals (composite, S-video, or component) will
output only in the resolution and format that matches
the input.
• HDMI input signals, regardless of their resolution, will
be output through the HDMI and analog component
outputs. Program material that carries HDCP encoding
will only be available through the HDMI output.
Note: If you are not getting the expected resolution options for your video
monitor, it may be caused by an incompability between the input setup
selections and the incoming signal. Refer to the Video Resolutions Table in
Section 6: Troubleshooting and Maintenance for more detailed
information.
VIDEO OUT
VIDEO OUT is a multi-purpose parameter; the function of the
parameter depends upon the input source and the setting of the
V-PROCESS parameter.
When the V-PROCESS parameter is set to BYPASS or CONV ONLY, the
VIDEO OUT parameter is a non-adjustable status display of the video
resolution of the output signal, as determined by the input.
When the Faroudja video processing is selected for the V-PROCESS
parameter and the output is a digital format, VIDEO OUT becomes
an active user-selectable parameter which identifies the video output
resolution. Available selections are AUTO, 1080i, 720p, and 480p.
The AUTO option, which is only applicable for HDMI configurations,
automatically selects the highest output resolution supported by an
HDMI-equipped monitor.
DIG AUDIO
Selects the DIG AUDIO parameter, which assigns one of the rear
panel digital audio input connectors to the current input. Available
selections include None, Optical 1-4, Coaxial 1-4, and HDMI 1-2.
The HDMI Audio & Video inputs, HDMI 1 and HDMI 2, are mutually
exclusive inputs - only one input is available at a time for each input
location. For example, while setting up the DVD input, if HDMI 2 is
selected for the Video Input, then HDMI 1 is not a selectable option
for the Digital Audio Input.
Note: Digital audio is not selectable for the Tuner, PC, and Dock inputs.
Refer to Section 5: Tuner, PC, and Dock Controls for more information.
INPUT SETUPSETUP
VIDEO OUT
INPUT SETUPSETUP
DIG AUDIO