User's Manual

Setup Lexicon
3-4
ASPECT RATIO 4:3, 16:9
Selects the ASPECT RATIO parameter, which assigns the appropriate
aspect ratio for the display device. The 4:3 aspect ratio is almost
square and most commonly used for television. The 16:9 aspect
ratio, also referred to as Widescreen, is almost twice as wide as it is
high.
Note: This parameter does not affect the OSD menus, which will always
be output to the monitor in 4:3 aspect ratio.
CONNECTION ANALOG, HDMI/DVI
Selects the CONNECTION parameter, which identifies the active
video output connectors on the MV-5 rear panel. The following list of
conditions identify the behavior of this parameter.
• If ANALOG is selected, only the analog video connectors are
available and will output the video signal.
• If HDMI/DVI is selected, both the analog and HDMI video
connectors are available and will output the video signal.
• If the video input is set to HDMI and the CONNECTION
parameter is set to ANALOG, then no video is output.
• If the HDMI video input is copy-protected (HDCP), no video is
output on the analog output connectors. This is a requirement
of HDCP and not a limitation of the MV-5 Processor
HDMI AUDIO OUT YES, NO
Selects the HDMI AUDIO OUT parameter, which identifies if audio is
sent on the HDMI output. If the HDMI Audio Out parameter is set to
YES, then a two-channel downmix of the source audio is sent over
the HDMI connection at the maximum bit rate of the display’s audio
system. This audio stream is in addition to the normal audio outputs.
If the parameter is set to NO, this audio is not sent.
2-LINE OSD OFF, 3, 4, 5, 6 SECONDS
Selects the 2-LINE OSD parameter from the On-Screen Display (OSD)
menu. The 2-Line OSD parameter identifies the length of time that
the 2-line OSD is displayed. The 2-Line OSD can be displayed from
three to six seconds in one-second increments. If OFF is selected,
then the 2-line OSD is not displayed.
MENU TIME OUT NONE, 30, 40, 50, 60 SECONDS
Selects the MENU TIME OUT parameter from the On-Screen Display
(OSD) menu. This parameter identifies the length of time before the
OSD menu times out. The parameter can be set from 30 to 60
seconds in ten-second increments. If NONE is selected, then the OSD
is always on when the MV-5 is on.
CAUTION!
The NONE selection should only be used with caution. If
the system includes a plasma screen, or other monitor
types sensitive to image burn-in, and the OSD Menu Time
Out parameter is set to NONE, the OSD menu image can be
burned into the plasma screen.
DISPLAY SETUPSETUP
ASPECT RATIO
DISPLAY SETUP
SETUP
CONNECTION
DISPLAY SETUPSETUP
HDMI AUDIO OUT
DISPLAY SETUPSETUP
ON-SCREEN DISPLAY 2-LINE OSD
DISPLAY SETUPSETUP
ON-SCREEN DISPLAY MENU TIME OUT