User's Manual

MV-5
2-7
11 POWER SWITCH
Use the Power Switch to connect or disconnect power from the AC
Input connector to the MV-5 Processor. When the MV-5 is powered
on, the front-panel Standby button or remote control ON & OFF
buttons can be used to activate and deactivate standby mode. When
the MV-5 is powered off, the standby and ON modes are not
available.
12 AC INPUT CONNECTOR
Provides power to the MV-5 through the supplied power cord.
13 TRIGGER OUTPUT CONNECTORS
Provides a 12V DC output to control connected components. Two
trigger output connectors are available as 3.5 mm mono mini
phone jacks. The OUT 1 connector, or power trigger, is not
configurable; it is activated when the MV-5 is powered on, and
deactivated when the MV-5 is powered off, either from the rear
panel or by putting the MV-5 into Standby mode. The OUT 2
connector can be configured independently for each input, refer to
Section 3: Setup for more information on how to configure the OUT
2 trigger.
Note: The OUT 2 trigger is referred to as “TRIGGER 2” in the Input Setup
menu.
14 RS-232 CONNECTOR
The RS-232 serial connector provides serial remote control through a
standard RS-232 connection. Refer to the Lexicon website
(www.lexicon.com) for more details on controlling the MV-5 Processor
via the RS-232 connection.
15 PREAMPLIFIER OUTPUTS
Provides outputs for optional, external power amplifiers for
applications that require them.
16 DOCK CONNECTOR
Provides an interface for an iPod, which can then be accessed
through the MV-5. To use this feature, the D-1 Dock option must
be installed to the DOCK connector. With a compatible iPod
connected to the MV-5, selecting the DOCK input allows you to
play audio files from the iPod. You can navigate the iPod using the
MV-5 remote and view any of the iPod menus through the MV-5
front panel and any video monitor connected to the MV-5. For
more information on the Dock option and how to use your MV-5
with an iPod, refer to Section 5: PC & Dock Controls.
17 ZONE 2 AUDIO OUTPUT CONNECTORS
Provides preamplifier audio outputs for Zone 2.
18 STEREO ANALOG AUDIO INPUT CONNECTORS
Provides stereo analog audio inputs. Six stereo analog audio input
connectors labeled 1 to 6 are available.
19 MICROPHONE INPUT CONNECTOR
Provides a microphone input for speaker calibration. The
microphone input is only for use with the supplied microphone
during the auto-calibration process.