User's Manual

Lexicon
2-4
6 ZONE 2 INPUT SELECTION BUTTONS
Individually selects each of the twelve inputs available in Zone 2.
When an input is selected, an amber LED lights on the
corresponding input selection button. When Zone 2 is deactivated,
pressing a Zone 2 input selection button activates the
corresponding input in Zone 2.
When the MV-5 is in Standby, pressing a Zone 2 input selection
button powers on the MV-5, selects the input in Zone 2, and turns
off the Main Zone.
7 ZONE 2 OFF BUTTON
Deactivates Zone 2. When Zone 2 is off, the Zone 2 OFF button on
the front panel lights red.
8 MAIN ZONE OFF BUTTON
Deactivates the Main Zone. When the Main Zone is off, the Main
Zone OFF button on the front panel lights red.
Note: Activating the Main Zone off button on the front panel turns off the
audio, however the video continues to be output through both the analog
and HDMI video outs. If using the HDMI Video In connection, only the
HDMI video is output. If the analog Video In is used, then both analog
and HDMI video is output. Main Zone OSD menus are also still available.
9 MUTE BUTTON
Mutes the Main Zone and Zone 2 volumes. Press the MUTE button to
mute the Main Zone volume level; “MUTE ON” appears in the 2-line
and OSD displays, and the MUTE button lights red. Press the MUTE
button again to restore the volume to its original level; the LED in the
MUTE button turns off. If a front panel Zone 2 input button is held
down, then pressing the MUTE button on the front panel will mute the
Zone 2 output and the MUTE button lights green.
Pressing the volume button once on the remote while the volume is
muted, turns off mute. Pressing and holding the Volume button,
while the sound is muted, resets to the original pre-mute volume
level and then increases or decreases the volume from that point,
turning off mute.
The LED in the MUTE button lights red when the Main Zone mute is
active, green when the Zone 2 mute is active, and amber when
both Zones are muted. The volume can also be muted by using the
MUTE button on the remote control, which functions in the same
manner.
10 ON/STANDBY BUTTON
Toggles the MV-5 between On and Standby. The rear panel Power
Switch must be set to the ON position for the Standby button to be
active. When the MV-5 is in the standby mode, pressing the
Standby button turns the unit on and changes the light in the
Standby button from red to blue. Power is still supplied to the MV-
5 when standby mode is activated.
When the rear panel Power Switch is initially set to the ON position,
the MV-5 automatically enters the standby mode.
Note: When taken out of standby, the MV-5 activates the Zones that were
active in the previous operating session.