User's Manual

MV-5
2-3
1 FRONT-PANEL DISPLAY
Use the front-panel display to view the current input source, input
type, listening mode, and volume level. If the built-in tuner is active,
the display will show the frequency band, selected frequency,
preset location, listening mode, and volume level. The 2 x 20
character display also functions as a display for messages and
menus, one line at a time.
2 IR RECEIVER
The IR receiver receives infrared commands from the MV-5 remote
control. Blocking the IR receiver will prevent the remote control
from functioning properly (unless using the optional RF-1 RF
Receiver).
3 VOLUME KNOB
Use the volume knob to adjust the volume level. The adjustable volume
range is -80 dB to +10 dB in 1 dB increments.
Note: The maximum volume level may be lower than +10 dB due to the
output level settings of the speakers. Refer to Section 3: Setup for more
information on setting the speaker output levels.
To adjust the Main Zone volume level:
Rotate the volume knob clockwise to increase or counter-clockwise
to decrease the volume level in 1dB increments. The current
volume level is indicated on the bottom right side of the 2-line front
panel display.
To adjust the Zone 2 volume level:
1. Press and hold the front-panel Zone 2 input selection button that
corresponds with the current input source. For instance, if DVD is
the current Zone 2 input source, press and hold the DVD input
selection button in the Zone 2 area of the front panel.
2. While holding down the input Zone 2 button, rotate the volume
knob clockwise to increase the volume or counter-clockwise to
decrease the volume. On the front panel 2-line display, the
bottom left side displays that Zone 2 is selected and the bottom
right side indicates the current volume level.
Note: If you attempt to set the volume higher than the maximum or lower
than the minimum volume levels, the volume parameter flashes on the
2-line front panel and OSD (On-Screen Display) displays.
4 MODE  and  BUTTONS
Use the Mode buttons to scroll to the previous () or next ()
available listening mode. Scrolling the mode button reveals the
entire list of listening modes available for the currently selected
input and mode family. For more information on selecting listening
modes, refer to Section 3: Setup.
5 MAIN ZONE INPUT SELECTION BUTTONS
Individually selects each of the twelve inputs available in the Main
Zone. When an input is selected, a blue LED lights in the
corresponding input selection button. When the Main Zone is
deactivated, pressing a Main Zone input selection button activates
the corresponding input in the Main Zone.
When the MV-5 is in Standby, pressing a Main Zone input selection
button powers on the MV-5, selects the input in the Main Zone,
and turns off Zone 2.