User's Manual

ManualsBrandsWoori Technology ManualsAV receiversAV Receiver

FRONT-PANEL CONTROLS

FRONT-PANEL CONTROLS 7

NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at

www.harmankardon.com.

The following controls and jacks are located behind the front-panel door. To open the door, place the edge of a finger on the left or right bottom edge of the panel and gently

swing the door down towards you.

Main Power Switch: Press this switch to

apply power to the AVR 7300. When the switch is

pressed in, the unit is placed in a Standby mode, as

indicated by the lighting around the Standby/On

Indicator 1 turning amber. The switch MUST be

pressed in to operate the unit. To turn the unit off and

prevent the use of the remote control, this switch

should be pressed until it pops out from the front

panel so that the word “OFF” may be read at the top

of the switch.

NOTE: This switch is normally left in the “ON” position.

Headphone Jack: This jack may be used to

listen to the AVR 7300’s output through a pair of

headphones. Be certain that the headphones have a

standard 1/4" stereo phone plug, or that you use an

adapter, as needed, to convert the plug on your head-

phones to the 1/4" jack used on the AVR. When the

headphone jack is in use, the main room speakers will

automatically be turned off and the unit will output a

standard stereo signal. You may also use one of the

Dolby Headphone modes for an enhanced listening

experience. For more information on headphone lis-

tening, see page XX.

Tone Mode Button: This button controls the

tone mode settings, enabling adjustment of the bass

and treble boost/cut. You may also use it to take the

tone controls out of the signal path completely for

“flat” response. The first press of the button displays a

TONE MODE message in the Lower Display

Line $ and in the on-screen display. To take the

controls out of the signal path, press either of the

¤/⁄ Buttons until the display reads

TONE OUT.To change the bass or treble settings,

press the button again until the desired option appears

in the Lower Display Line $ and in the on-screen

display and then press either of the ‹/› Buttons

to enter the desired boost or cut setting. See

page XX for more information on the tone controls.

Speaker Selector Button: Press this button

to begin the process of configuring the AVR 7300 for

the type of speakers it is being used with. For com-

plete information on configuring the speaker settings,

see page XX.

Channel Adjust Selector: Press the button to

begin the process of adjusting the channel level out-

puts using the source currently playing through your

DPR. For complete information on adjusting the chan-

nel output level, see page XX.

Digital Input Selector: Press this button to

begin the process of selecting a digital source for use

with the currently selected input. Once the button has

been pressed, use the

¤/⁄ Buttons to

choose the desired input and then press the

Set/Video Button to enter the setting into the

unit’s memory. See page XX for more information on

digital audio.

9

8

6

5

4

8

3

2

1

1 2

Main Power Switch

Headphone Jack

Tone Mode Button

Speaker Selector Button

Channel Adjust Selector

Digital Input Selector

Delay Adjust Selector

‹

›

Buttons

Set/Video Button

Optical 4 Digital Input

Optical Digital Output

Coaxial 4 Digital Input

Coaxial Digital Output

Video 5 Audio/Video Jacks

Input/Output Indicator

1

2

3

4

5

6

7

8

9

0

11 

2

3

4

5