User's Manual

APPENDIX
S
YSTEM DEFAULTS
The two tables in this section show the factory default settings for the Video Inputs and Video Sources. These tables give you a picture of the AVR 645’s initial settings. You may
then decide whether any item needs to be changed so that it is more appropriate for your specific installation. Any of the settings shown may be changed as shown in the
pages of the System Configuration section of this manual (pages 21–33).
TABLE 1: VIDEO INPUT DEFAULTS
INPUT AUDIO VIDEO COMPONENT TRIGGER 2 RECORD AUTO-POLL INPUT
INPUT INPUT VIDEO INPUT SETTING OUTPUT SOURCE TYPE
Video 1 ANALOG AUTO COMPONENT 1 ON ANALOG ON VCR
Video 2 ANALOG AUTO COMPONENT 2 ON ANALOG OFF CABLE DIGITAL
Video 3 OPTICAL 1 AUTO COMPONENT 1 ON ANALOG ON CABLE ANALOG
Video 4 OPTICAL 4 AUTO COMPONENT 2 ON ANALOG ON SATELLITE DIGITAL
DVD COAX 1 AUTO COMPONENT 3 ON ANALOG OFF DVD
HDMI 1 HDMI 1 HDMI 1 --- ON DSP DOWNMIX OFF *
HDMI 2 HDMI 2 HDMI 2 --- ON DSP DOWNMIX OFF *
Tuner ANALOG AUTO COMPONENT 1 ON ANALOG --- *
XM --- HDMI 1 COMPONENT 1 ON ANALOG --- *
CD ANALOG AUTO COMPONENT 3 ON ANALOG OFF *
Tape ANALOG AUTO COMPONENT 1 ON ANALOG OFF *
DMP/The Bridge ANALOG HDMI 1 COMPONENT 1 ON ANALOG --- *
6/8 CH Direct ANALOG HDMI 1 COMPONENT 1 ON ANALOG --- *
USB --- HDMI 1 COMPONENT 3 ON DSP DOWNMIX --- *
TABLE 2: VIDEO SOURCE DEFAULTS
FEATURE DVD VCR CABLE DIG SAT DIG SAT ANALOG CABLE ANALOG CAMERA DIG CAMERA ANALOG
Noise Reduction OFF ON OFF OFF ON ON OFF ON
X-Color Suppressor ON ON ON ON ON ON ON ON
DCDi Interpolation ON ON ON ON ON ON ON ON
Film Mode Detect ON ON ON ON ON ON ON ON
Film Mode Edit Detect ON ON ON ON ON ON ON ON
Composite Video Enhancement ON ON ON ON ON ON ON ON
VCR Sync Time Enhancement ON ON ON ON ON ON ON ON
System Default and Personal Settings Worksheets
The worksheets in this section show the system defaults for the global settings on your AVR 645. Once your system is configured manually, or through the use of EzSet/EQ II,
where applicable, we recommend that you use the “Your System Settings” column to record your personal preferences so that they may be restored in the event the AVR’s
memory is lost due to an extended power outage, system upgrade, processor reset, or other major service to your unit. Additional copies of this worksheet may be downloaded
from the Harman Kardon web site at www.harmankardon.com
Worksheet A: Video Monitor and Aspect Ratio Defaults and Settings
Feautre/Display Type System Default Your System Setting
Display Interface Analog
HDMI Audio Out Off
CR
T
4:3
F
ront Projection
4:3
Rear Projection 4:3
Plasma (PDP) 16:9
DLP™ 16:9
LCD 16:9
APPENDIX
57
*: User should change setting to match input type.