User's Manual

Screen Program Code (Automatic)

If ON/OFF codes could not be found by Brand in the Manual Mode, try searching by source type

in the Automatic mode.

In the SCREEN CODE PROGRAM screen, press the ▼/▲Navigation Button [oval 16] to move the

cursor next to: AUTOMATIC. Press the Set Button [oval 18]. The SCREEN AUTO PROGRAM

screen will appear.

The SOURCE will be fixed as selected (SCREEN). Press the ▼ Navigation Button [oval 16] to

move the cursor next to: TRY CODES. Repeatedly press the ◄or► Navigation Button [oval 16]

to test all selected device type commands until the unit turns off. When the unit turns off, press

the ▼ Navigation Button [oval 16] to move the cursor next to: YES. Press the Set Button [oval

18] to ‘save’ the code group. This will set this code group for ON/OFF control of the Screen.

If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote

and then the Exit Button [oval 17] to return to normal operation mode.

To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK

TO SCREEN CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button

[oval 16] again to move the cursor next to: BACK TO SCREEN CNTL SETUP. Press the Set

Button [oval 18]. The SCREEN CONTROL SETUP screen will appear.

To program TV/PROJECTOR ON/OFF, LIGHTING ON/OFF, CURTAIN OPEN/CLOSE, press the

▼/▲Navigation Button [oval 16] to move the cursor next to: BACK TO REM CNTL SETUP.

Press the Set Button [oval 18]. See the Screen and Lighting sections.

If a particular brand or functional codes from a source type cannot be found in the on-board IR

code Library, IR commands for Screen UP/DOWN can be taught to the AVR from the original

equipment remote. To teach Screen UP/DOWN codes to the AVR, proceed to section: Learn

Code.

Screen Program (Learn Code)

To teach the AVR21EN Screen ON/OFF codes, in the SCREEN CONTROL SETUP screen, press

the ▼ Navigation Button [oval 16] to move the cursor next to: LEARN CODE. Press the Set

Button [oval 18]. The SCREEN CODE LEARN screen will appear.

With the cursor positioned next to USING THE ◄ ► KEYS line, press the Set Button [oval 18].

The message: USING THE ◄/► KEYS SELECT FUNCTION TO BE PROG will start to flash,

indicating a function can be selected for learning. Press the ◄ Navigation Button [oval 16] to

select SCREEN POWER ON. When the ON function appears, press the ▼ Navigation Button

[oval 16] to position the cursor next to POINT ORIGINAL REM TO AVR DISPLAY PRESS KEY.

Press the Set Button [oval 18]. The POINT ORIGINAL… message will start to flash. Point the

original remote toward the IR Sensor [square 31] in the Information Display [square 25] on the

AVR front panel and press the button with the original code until the message stops flashing and

CODE LEARNED appears on screen.

The cursor will automatically return to the USING THE ◄ ► KEYS line. Repeat steps above to

program the OFF command.

If CODE NOT LEARNED appears, try to learn the code again. In some cases, it may be a good

idea to replace the original remote’s batteries to improve signal output from the remote. In some

cases, there will be codes that the AVR just is not capable of learning. Contact the Audioaccess

Technical Service Department for advice in such a case.